Week 1: We put 2 blocks together and a gray Lego. We were putting motors and sensors. We are connecting the wires to the motor. We have to go back because have no gears. The problem is we don't know how to put them on. Today we tried to put them on, but the gears aren't reaching each other. Week 3: Today we think we know how to put the gears on! Then we tried it and it worked!!!!!!! To put on the gears, we built a platform by our motor. Then, we put a connector to one of our pieces. We finally put on the gears. To put on the gears we built a platform by our motor. Then we put a connector to one of our pieces. Finally! Week 4: To Robodude aon con wait 20 aoff coff End That is our first download! Yippee! That means both motors on for 2 seconds, then both motors off.   Week 5: Jared was the first to find that you can change it's course by turning one our wired Lego. Today we put in the program on the other page to robodude or our robot. When we went to download, it said there was no connection, so we thought about what was wrong. Finally Brandon said to Jared did you put it on? He said "No." Once we turned it on, it downloaded. Week 6: Today our program was confusing because it was not downloading. We struggled our whole period until Mr.Cattanach found out how to download ours. Dang, it's over, and we just got to the hard part! Thank goodness!! We finished this hard, demanding project!! Even though we went through these hard working weeks, we got through this!! Congratulations to Jen, Brandon, Sharon, Marnie, and Jared! (us) WHOOOOOOOO WHOOOOOOOOOOOO!!!! A LITTLE EXCITED THERE! SORRY!