Our robot was built with two motors, a light sensor, and teamwork. At first we had lots of problems until we solved them. Our first problem was our robot would not stay together so we made a new accurate body. That didn't work either so we went over our steps that we wrote down and tried that same body over again. But it fell apart again, so we put the parts on another time, finally it worked. We then put on the gears, four wheels and the yellow brick logo. We then got to the programming, this is our program.   to gofast ac, thatway onfor 20 repeat 3 [a, onfor 10 beep wait 10] repeat 3 [b, onfor 10 beep] repeat 3 [c, onfor 10 beep] repeat 3 [abc, onfor 20 beep] repeat 4 [abc, onfor 34 beep] repeat 5 [ab, onfor 50] repeat 1 [abc, onfor 60 beep] repeat 9 [ ac, onfor 20] repeat 40 [ ac, onfor 9] loop [a, onfor 10 beep wait 10] end